76
Anode Replacement
Water Separator Inspection and Service
SERVICING YOUR OUTBOARD MOTOR
ANODE
(each side)
ANODE
(stern bracket)
RED FLOAT
WINDOW (2)
STANDOFF (2)
‘‘I’’ MARK
BOWL
ENGINE OIL
FILTER
WATER SEPARATOR
Painting or coating the anodes will
def eat their purpose and will lead to
rust and corrosion damage to the
outboard motor. The anodes must be
exposed to the water in order to
protect the outboard motor.
If the engine is operated with the water in the water separator, water can
enter the f uel injection system resulting in f uel system damage.
Anodes are located on each side of
the gearcase. They are made of a
sacrificial material and help protect
the outboard motor from corrosion.
Replace the anodes when they are
reduced to about half their original
size, or if they are crumbling.
A water separator is located below the engine oil filter. If water gets past the
water separator, the water can cause loss of power, hard starting, and/or
possible fuel injection system damage. Check the water level in the water
separator before each use. The red float will indicate the water level. When
the red float lifts off the bottom of the bowl or if the red float is not visible,
remove and clean the water separator. Consult with an authorized Honda
Marine dealer for cleaning if necessary.
02/10/28 13:56:39 31ZW5601_077