55
INSTALLATION
<Remote Control Box Location>
Install the remote control box in the
position where is easy to operate the
remote control lever and switches.
Mechanical wire type:
Be sure that there are no obstacles on
the route of the control cable.
The control box position of the D1
type, D2 type, R2 type and the R3
type should be determined in the
same manner.
<Remote Control Cable Length>
(Mechanical wire type)
Measure the distance from the control
box to the outboard motor along the
cable routing.
Recommended cable length is
300 – 450 mm (11.8 – 17.7 in) longer
than the measured distance.
Set the cable along the predetermined
route and be sure that it is long
enough to the route.
Connect the cable to the engine and be
sure it is not kinked, bent sharp, pulled
taut, or interfered while steering.
Do not bend the remote control
cable as sharp as its route diameter
is 300 mm (11.8 in) or less, or it
affects the service life of the cable
and the remote control lever
operation.
REMOTE
CONTROL
LEVER
REMOTE
CONTROL BOX
REMOTE
CONTROL
CABLE
(Mechanical
wire type)
42ZVL600.book 55 ページ 2018年7月19日 木曜日 午前9時6分