NEVER START BF2A MOTORS OUT OF WATER!
This results in immediate water pump failure which causes the
motor to overheat. The motor will continue to operate but
damage to the motor occurs.
A malfunctioning water pump will also cause overheating and
present a
potential burn hazard to operators and passengers of the boat.
1. Open boxes and examine merchandise to make sure all equipment matches
what is listed on the packing slip and was not damaged during shipment.
2. Immediately fill Honda BF2 Bumper Boat motors with oil—Honda
recommends using 10w-30 Detergent Motor Oil.
3. Read the Honda BF2 Owner’s Manual and Shop Manual form thoroughly.
WARNING
1. Add oil.(10w-30 is recommended.)
2. DO NOT start BF2A motors out of water. (Damage and burn hazard can
result.)
3. Read owner’s manual and shop manual thoroughly.
4. Open fuel cap vent knob 2 to 3 turns counter clockwise.
5. Turn the fuel valve lever on.
6. Pull starter rope straight out. (Damage will occur to starter or gas tank if
pulled in any other direction.)
7. Use clean unleaded gasoline. (
Never
use oil/gas mixture.)
8. Check lower gear case oil. (Marine SAE 90 Hypoid oil.)
9. Motor is now ready for installation in boat.
BREAK IN PROCEDURES
1. Read owner’s manual, regarding break in procedure.
2. Start all motors (see starting procedures on page 4).
3. After first 20 hours of operation:
Section 2, page 1
X:\Customer info request\Manuals & Parts Book Bumper Boat\Bumper Boat Manual\Break-In.pub
