Honda 2009 Fit, Owner'S Manual, Page: 174 / 597

Continued
173
uu Operating the Switches Around the Steering Wheel u High Beam Support System *
Co
ntrols
Turn the headlight switch in AUTO and pull
the headlight lever to low beam.
2 Light Switches P. 167
The high beam support system indicator
comes on.
■
Temporary cancellation
The high beam support system operation is temporarily cancelled while:
• You are continuously driving at a speed below 24 km/h (15 mph).
• The vehicle speed is below 10 km/h (6 mph).
• The windscreen wipers run at high speed for more than a few seconds.
The system operation resumes once the condition that caused it to cancel improves.
■
To Operate the System
1 To Operate the System
For the high beam support system to work properly:
•
Do not place an object that reflects light on the
dashboard.
•
Keep the windscreen around the camera clean.
When cleaning the windscreen, be careful not to
apply the windscreen cleanser to the camera lens.
•
Do not attach an object, sticker or film in the area
around the camera.
•
Do not touch the camera lens.
If the camera receives a strong impact, or repairing of
the area near the camera is required, consult a dealer.
To help reduce the likelihood that high interior
temperatures will cause the camera system to shut
off, when parking, find a shady area or face the front
of the vehicle away from the sun.
If you use a reflective sun shade, do not allow it to
cover the camera housing. Covering the camera can
concentrate heat on the camera.
If the message appears:
•
Use the heating and cooling system * /climate
control system * to cool down the interior and, if
necessary, the demister mode when windows are
fogged.
•
Start driving the vehicle to lower the windscreen
temperature, which cools down the area around
the camera.
Headlight Switch
* Not available on all models
16 FIT JAZZ -32T5A6000.book 173 ページ ２０１５年８月１９日 水曜日 午後１時３８分