Remove the dipstick again, and
check the level. It should be
between the upper and lower
marks.
If it is near or below the lower mark,
see
on page
.
Wait a few minutes after turning the
engine off before you check the oil.
Remove the dipstick (black
handle).
Insert the dipstick all the way back
into its hole.
Wipe off the dipstick with a clean
cloth or paper towel.
To close the hood, lift it up slightly to
remove the support rod from the
hole. Put the support rod back into
its holding clip. Lower the hood to
about a foot (30 cm) above the
fender, then let it drop. Make sure it
is securely latched.
Holding the grip, pull the support
rod out of its clip. Insert the end
into the designated hole in the
hood.
3.
4.
1.
2.
3.
Service Station Procedures
Adding Engine Oil
Oil Check
B
e
fo
re
D
riv
ing
113
UPPER MARK
LOWER MARK
DIPSTICK
CLIP
SUPPORT ROD
GRIP
Main Menu
Table of Contents
Summary of Contents for 2007 S2000 SECURITY SYSTEM
