© 2009 American Honda Motor Co., Inc. - All Rights Reserved.
AII 42593 (0909)
1 of 3
INSTALLATION
INSTRUCTIONS
Accessory
Application
Publications No.
Issue Date
SEPT 2009
08L03-TA1-2000-91
2010 CR-V
BIKE ATTACHMENT
P/N 08L07-TA1-102
PARTS LIST
Bike attachments
2 Wheels Straps
2 End Caps
2 Keys
AII 42593
Put this information in the glove box with the vehicle owner's manual.
Preparing the Bike Attachment
1.
Slide the wheel strap onto one end of the bike
attachment channel. Repeat on the other end.
Make sure both wheel strap buckles are on the
same side.
2.
Install an end cap on the bike attachment channel
by aligning the locktabs on the end cap, with the
holes in the channel. Push down on the endcap
until the lock tabs "click" into place. Repeat on
the other end.
TOOLS REQUIRED
Flat-tip screwdriver
Shop towel
Utility Knife
INSTALLATION
NOTE:
• Be careful not to damage the painted surfaces of
the vehicle when installing the bike attachment.
• If you are installing more than one bike attachment,
you may need to alternate the mounting positions
(front to rear) to allow for handle bar clearance.
• Make sure the security retainer and the locking
clamp lever are installed on the outboard side. See
the instruction sheet for details
WHEEL
STRAP
BIKE ATTACHMENT
END CAP
BIKE ATTACHMENT