Assembly Instructions 2/2
IMPORTANT
Use a soft cloth between these parts and the floor.
Do not use power tools above 8 volts to assemble.
Do not tighten all the bolts until each part is properly assembled.
The unit must be level to work properly. Use the included adjustable levelers to level.
Keep Hex Wrench in a safe place as the bolts may need to be tightened up in the future.
Figure 1
Figure 2
Figure 3
Cover
Head Cap Bolt
Flat Washer
Spring Washer
Head Cap Bolt
Flat Washer
Spring Washer
STEP 3
Turn the unit over to its’ upright position.
Cover the umbrella hole with Cover.
To level the unit, adjust the adjustable levelers
on the bottom of the legs. (See Figure 3)
STEP 2
Attach Stretchers (C) to unit with Flat Washers,
Spring Washers and Head Cap Bolts, tightening
the bolts only half way. (See Figure 2)
Tighten all Head Cap Bolts used in Steps 1 and 2.
B
B
B
B
A
C
STEP 1
Place Top (A) upside down on a soft cloth.
Attach Legs (B) to Top (A) with Flat Washers,
Spring Washers and Head Cap Bolts,
tightening the bolts only half way.
(See Figure 1)
