HomeSeer Flex Sensor HS-FS100+ User Manual Download Page 1

HomeSeer | 10 Commerce Park North, Unit 10 | Bedford, NH 03110 | HomeSeer.com | Doc: HS-FS100-en-v1.0 

 

Multi 

Sensor 

HS-FS100+

Applications

 

Use to trigger events based on changes in temperature 

Use the built-in buzzer as an audible notification that triggers when things happen in your home 

Use with optional light sensor to trigger events when indicator lights on appliances turn on or off 

Example: 

“Dehumidifier is full” indicator turns on 

Use with optional water sensor to trigger events when water is detected near basement walls, plumbing fixtures or appliances 

Configuration

 

Flex Sensor is equipped with a Z-Wave network button (for inclusion/exclusion), LED indicator and micro USB connector for use with an AC 
power adapter (not included). A 3.5mm jack is also provided for connection to the optional wired light or water sensors. Z-Wave commands 
are used to transmit temperature, light and water detection data and to control the built-in buzzer.  

Physical Installation

 

Install 3 AAA batteries (not included) inside Flex Sensor and mount it in the location of your choice using the supplied double-stick tape, 
mounting plate and mounting hardware.  

Z-Wave Network Installation  

Use the instructions below to 

include 

or 

exclude 

Flex Sensor to/from your Z-Wave network.

 

Inclusion

 

1) Attach light or water sensor cable (if available). Put your home automation controller into Z-Wave ‘inclusion’ mode.
2) Press the Z-Wave network button on the front of the unit one time. Wait for the inclusion process to finish. This may take some time.

Exclusion 

1. Put your home automation controller into Z-Wave ‘exclusion’ mode.
2. Press the Z-Wave network button on the front of the unit one time. Wait for the inclusion process to finish. This may take some time.

Reset 

(Use this procedure to reset Flex Sensor to factory settings when the Z-Wave controller is missing or otherwise inoperable). 

1. Press and hold the Z-Wave button inside the sensor body for 10 seconds. If successful, the LED will flash 5 times. 

Built-in Temperature Sensor

 

The temperature sensor is designed to transmit temperature data to your controller using Z-Wave commands every 60 minutes (on battery 
power). That interval may be changed when the unit is line powered. See parameter settings on page 2 for details. 

Optional Light Sensor

 

The light sensor can be mounted over any indicator light and will notify your controller with a Z-Wave command and will beep 5 times 
when light is detected. Another Z-Wave command will be sent to the controller when light is no longer detected. This sensor will check for 
light every 60 seconds (on battery power) or every 400 ms (on line power). 

Optional Water Sensor

 

The water sensor is designed to detect moisture along the entire length of its cable. This is especially useful for detecting leaks over extend-
ed distances and around appliances. Optional extension cables may be added for coverage of up to 300 feet. The sensor will notify your 
controller with a Z-Wave command and will beep 5 times when the water is detected. Another Z-Wave command will be sent to the con-
troller when water is no longer detected. This sensor will check for water every 60 seconds (on battery power) or every 400 ms (on line 
power). 

Buzzer

 

The built-in buzzer emits a single beep when activated with a Z-Wave command. 

OVERVIEW

 

HS-FS100+ (“Flex Sensor”) is a multifunction module that includes a temperature sensor, controllable buzzer and a port to connect optional 
external light or water sensors. It is designed to control other Z-Wave devices directly or it may be used with a variety of Z-Wave certified 
home controllers to launch automation events or scenes.

 

Reviews: