51
Mounting
5
Mounting
For operation of the floor heating actuator with
24 V, a 24 V/50 Hz power supply is required. We
recommend you to use the Homematic IP Trans-
former for Floor Heating Actuators – 24 V (HmIP-
FAL24-TR).
When using the floor heating actuator in combination
with the Homematic IP Transformer for floor heating ac-
tuators - 24 V (HmIP-FAL24-TR), it is recommended to
install the device on the supplied DIN rail. For mounting
the floor heating actuator and the transformer to a DIN
rail, please proceed as follows:
• Please select a suitable mounting location close
to your heating manifold.
Make sure that no electricity or similar lines run in
the wall at this location!
• Use a pen to mark two bore holes for mounting
the DIN rail on the wall.
• Use an appropriate drill to make the holes as illus-
trated.
• Fasten the screws and plugs supplied to mount
the DIN rail.
• Place the floor heating actuator onto the DIN rail
(
see fig. 3
).
• Latch the floor heating actuator by pressing the
Summary of Contents for HmIP-FAL24-C6
Page 3: ...1 A G B E C H D F ...
Page 4: ...2 3 K I J ...
Page 5: ...4 5 ...
Page 6: ...6 7 Selecttaste drücken Systemtaste drücken press select button press system button ...
