50
51
Operation
Restore factory settings
6.3
Configuring newly taught-in devices
Once you have taught-in your switch actuator to the
HomeMatic Central Control Unit, it will be moved to
the inbox. Here, you must configure the device and its
associated channels in order to make them available
for operating and configuration tasks. Give the device
a name and assign it to a room. You can also make
individual parameter settings.
Now you can use the “WebUI” user interface to control
your device, configure it, connect it directly to other
devices, or use it in central control unit programs.
Please refer to the HomeMatic WebUI Manual for
more details (you can find this in the “Downloads” area
of the website www.homematic.com).
7 Operation
After teach-in has been performed, simple operating
functions are available via the taught-in control ele-
ments (e.g. HomeMatic remote controls).
Depending on the taught-in control element, the switch
actuator can be controlled by means of an ON/OFF
pair of buttons or by toggling.
8 Restore factory settings
When the factory settings of the device are
restored, all settings will be deleted.
To reset the actuator to its as-delivered condition,
proceed as follows:
•
Activate the teach-in mode of the connected push
button by pressing and holding down the button for
at least 4 seconds, until the device LED will start
flashing.
•
Release the button.
•
Press and hold down the button again for 4 seconds
in order to restore the factory settings of the device.
If the device LED flashes quickly, this indicates that the
actuator is being reset.