52
Restore factory settings
6x long red
flashing
Device defec-
tive
Please see your app
for error message or
contact your retailer.
1x orange, 1x
green lighting
(after inserting
batteries)
Test display
Once the test display
has stopped, you can
continue.
8
Restore factory settings
The factory settings of the device can be restored.
If you do this, you will lose all your settings.
To restore the factory settings of the device, please pro-
ceed as follows:
• Loosen the electronic unit
(B)
from the bracket
(A)
by pushing it upwards and removing it to the
front
(see figure 2)
.
• Remove a battery.
• Insert the battery ensuring that the polarity is
correct and press and hold down the system
button
(C)
for 4 s at the same time, until the LED
(C)
will quickly start flashing orange
(see figure 10).
• Release the system button again.
• Press and hold down the system button again for 4
seconds, until the LED lights up green (
see figure 11
).
• Release the system button to finish the procedure.
The device will perform a restart.
Summary of Contents for HmIP-SWDM
