49
Start-up
5.2
DIN rail mount
For mounting the floor heating actuator to a DIN rail,
please proceed as follows:
• Place the floor heating actuator onto the DIN rail
(
see figure 4
).
• Latch the floor heating actuator by pressing the
spring latches
(G)
upwards (
see figure 4
).
• Make sure that the spring latches are completely
latched and that the device is seated solidly on
the rail.
6
Start-up
6.1
Installation instructions
Please read this entire section before starting to
install the device.
For installing the floor heating actuator into a
power distribution panel it has to be mounted in
accordance with VDE 0603, DIN 43871 (low-volt-
age sub-distribution board), DIN 18015-x. In this
case, the installation must be made on a mount-
ing rail (DIN rail) according to EN50022. Installa-
tion and wiring have to be performed according
to VDE 0100 (VDE 0100-410, VDE 0100-510 etc.).
Please consider the technical connection re-
quirements (TAB) of your energy supplier.
