Continue to press and hold the HomeLink button while you press and release - every two
seconds (“cycle”) your hand-held transmitter until the HomeLink indicator light changes to
either rapidly flashing green (rolling code) or continuously lit green (fixed code). Now you
may release both the HomeLink and hand-held transmitter buttons.
Proceed with “Programming” step 4 to complete.
Erasing HomeLink Buttons
To erase programming from all the three buttons (individual buttons cannot be erased but can
be “reprogrammed” as outlined below), follow these steps:
1.
Press and hold the two outer HomeLink buttons for at least 10 seconds,
until
the
indicator light will change from continuous orange to rapidly flashing green.
2.
Release both buttons.
Note:
Do not hold for longer than 20 seconds.
3.
HomeLink is now in the train (or learning) mode and can be programmed at any time
beginning with “Programming” - step 1.
Reprogramming a Single HomeLink Button
To program a device to HomeLink using a HomeLink button previously trained (shown by a
green indicator) follow these steps:
1. Press and hold the desired HomeLink button.
DO NOT release the button.
2. The indicator light will begin to slowly flash orange after 20 seconds. The HomeLink button
can be released at this point. Proceed with “Programming HomeLink” - step 2.
If additional programming support is needed, please call the toll-free HomeLink Hotline at
1-800-355-3515.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End Users must follow the specific operating instructions for satisfying RF
exposure compliance. This transmitter must be at least 20 cm from the user and must
not be co-located or operating in conjunction with any other antenna or transmitter.
FCC (USA) and IC (Canada):
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End Users must follow the specific operating instructions for satisfying RF
exposure compliance. This transmitter must be at least 20 cm from the user and must
not be co-located or operating in conjunction with any other antenna or transmitter.
