A
S
A - Shelf x 6
A
ssemb
Assembling the posts
Safety I
b
ly
Inform
B – Tapered Sleeves x 48
Spare Plastic Tapered
Sleeves x 2
mation
D
Us
se an
2
nd Ca
are Guuide
t
Model #
#EH-WSHDI-001
®
PACKAGE CONTENTS
C - Bottom Poles
with Levelers
Pre-installed x 4
D – Top Poles with Pole Connector
& Caps Pre-installed x 4
Screw a bottom pole (C) to top pole (D). Repeat for the
remaining bottom and top poles (C and D ).
Assembling the bottom shelf
Locate the desired position of the bottom shelf (A). Ensure that it is
no more than 6 in. from the floor.
Place two tapered sleeves (B) into the appropriate groove on each
pole assembly. Ensure the tapered end is up (see arrow on sleeve.)
Place the shelf (A) on its side and slide each pole assembly with
tapered locks through the bottom of the shelf (A) until snug.
After all pole assemblies are in place, position the unit in the upright
position.
Push down on each corner of the shelf (A), ensuring the shelf (A) is in
a fully locked position.
Locate the desired position of the next lower shelf and
place the tapered sleeves (B) on the pole assemblies.
Slide the shelf (A) down from the top pole assemblies
and onto the tapered sleeves (B).
Push down on each shelf (A) corner , ensuring the shelf
(A) is in a fully locked position.
Repeat for the remaining shelves (A).
Center the backstand(F) along the back of the shelf. Insert
the bent foot of one end anchor of the backstand(F) on the
inside of the back shelf wire. Once the bent foot is inside
the back wire, pull backstand(F) out away from the rack
until the straight foot locks on the outside of the back wire.
Repeat for the 5 other backstands.
Move the assembly to the desired position.
If required, adjust the levelers (G) on the bottom of the bottom poles (C )
to ensure the assembly is level. Rotate the levelers (G) counterclockwise
to raise the poles, clockwise to lower the poles.
If wheels are required ,un-screw levelers (G) from bottom poles,screw in two
locking wheels (E) on one side of the unit and two regular wheels (E) on the
other side of the unit.Use the provided wrench to tighten all the way.
Adding shelves and backstands
Adjusting the levelers
1. Two adults are recommended for ease of assembly. Use care when
handing.
2. Assembly recommended on a soft surface, such as carpet, to avoid
scratching flooring finish.
3. Discard the black circular plastic pieces.These are used to separate
the shelves for shipping purposes.
CAUTION: Do not allow children to climb or play in or
around the shelves.
CAUTION:Each shelf holds up to 500lbs, evenly distributed.
Static load total 600lbs with casters.Do not overload.
HOMEDEPOT.COM
Please contact 1-800-514-6729 for further assistance.
1
4
3
A
A
C
D
E – Wheel x 2
Wheel with lock x 2
Wrench x 1
F – backstands x 6
C
G – Levelers x 4
Pre-installed on the
Bottom Poles (C)
B
6 Tier Industrial Using
Shelving
B
C
F
G
E
I em #204603381