OPERATION
28
WP50ECO | WP75ECO
15.3
Handling
1.
Place the working table to the required height position.
Upwards:
•
Remove the bed frame pins (2)
•
Move the working table to the desired position with the
hand winch (3).
•
Insert and secure the removed bed frame pins (2) in
position (1)
•
Lower the working table onto them
•
Then attach the two bed frame pins (1) to position (2) for
final fixing
Downwards:
•
Remove the bed frame pins (1)
•
Insert the bed frame pins (1) into the desired position and
secure it.
•
Hold the working table in position with the hand winch (3)
and remove the two bed frame pins (2).
•
The working table can then be lowered to the desired
position using the hand winch (3)
•
Fix and secure the working bed with the bed frame pins (2)
2.
Place the workpiece support (1) or other supporting/clamping
device adapted to the workpiece on the working table. Then
place the workpiece on the workpiece support.
NOTE:
Position the workpiece centrally (working table/cylinder)
CAUTION:
Only select supporting/clamping devices that are
designed for the permissible pressing force and provide the
workpiece with a secure hold during the complete pressing
process.
Examples of workpiece positioning:
3.
Moving the stamp towards the workpiece:
With compressed air supply:
•
Connect the air inlet fitting to the fitting of the air supply hose
•
Close the pressure valve (3).
•
Pump the handle (1) or open the air valve (2) until the stamp nears
the workpiece
With compressed air supply:
•
Close the pressure valve (3).
•
Pump the handle (1) until the stamp nears the workpiece
