ASSEMBLY
15
WB210C
prescribed transport position, etc. Pay attention to the correct body posture when lifting, carrying
and setting down the load.
Lifting / Setting down
-
When lifting/setting down, ensure that you are standing firmly (legs hip-width apart).
-
Lift/set down load with knees bent and back straight.
-
Do not lift/set down load with a jerk.
Carrying
-
Carry load with both hands as close to body as possible.
-
Carry load with straight back.
Always secure the assembled product when transporting it to prevent damage to the product.
ASSEMBLY
12.1
Delivery content
Check the delivery immediately for transport damage and missing parts. Report any damage or
missing parts to your dealer or the shipping company immediately. Visible transport damage must
also be noted immediately on the delivery note in accordance with the provisions of the warranty,
otherwise the goods are deemed to have been properly accepted.
12.2
Requirements for the installation site
Place the product on a level, solid surface. Observe the safety requirements and the dimensions of
the product. The chosen installation site must comply with the local safety regulations and meet
the ergonomic requirements for a workplace with sufficient lighting conditions.
12.3
Assemble
Assemble the product in pairs as described below:
1.
Assembly base frame
Place a connecting nut (1) in the opening of
the frame brace. Make sure that the slot is
aligned horizontally.
Insert the wooden dowel of the frame brace
into the corresponding hole of the foot (2).
Mount the frame brace with the foot and the
hexagon socket screw (3). The connecting nut
stabilises the frame.
Do not tighten the hexagon socket screw too
much yet.
Repeat this procedure with the 2
nd
foot and
with the other 3 frame braces (3).
When arranging the feet, make sure that the
pegs for the worktop are in the same
height (4).
