
HOLZMANN Maschinen Austria
www.holzmann-maschinen.at
Seite 34
Bedienungsanleitung DF 1200N
9
TROUBLESHOOTING
Problem
Possible Cause
Solution
Excessive Vibration.
1. Workpiece warped, out of
round, has major flaw, or
was improperly prepared for
turning
2. Worn spindle bearings
3. Worn belt
4. Motor mount bolt or han-
dle loose
5. Lathe on uneven surface
1. Correct problem by planing, band-
sawing, or scrap workpiece all together
2. Replace bearings
3. Replace belt
4. Tighten bolt or handle
5. Shim lathe bed, or adjust feet on
stand
Motor or Spindle
Stalls or Will not
Start
1. Excessive cut
2. Worn motor
3. Broken belt
4. Worn spindle bearings
5. Improper cooling on motor
1. Reduce cut depth
2. Replace motor
3. Replace belt
4. Replace bearings
5. Clean sawdust from motor fan
Motor fails to devel-
op full power.
1. Power line overloaded
2.Undersize wires in supply
system
3. Low voltage
4. Worn motor
1. Correct overload condition
2. Increase supply wire size
3. Request voltage check from power
company and correct low voltage condi-
tion
4. Replace motor
Tools tend to grab or
dig in.
1. Dull tools
2. Tool support set too low
3. Tool support set too far
from workpiece
4. Improper tool being used
1. Sharpen tools
2. Reposition tool support height
3. Reposition tool support closer to
workpiece
4. Use correct tool for operation
Digital readout does
not work
1. Digital readout sensor out
of position
1. Open the belt access and position the
sensor so that it reads the bolts
Summary of Contents for DF 1200N
Page 19: ...HOLZMANN Maschinen Austria www holzmann maschinen at Strana 19 Bedienungsanleitung DF 1200N ...
Page 20: ...HOLZMANN Maschinen Austria www holzmann maschinen at Strana 20 Bedienungsanleitung DF 1200N ...
Page 37: ...HOLZMANN Maschinen Austria www holzmann maschinen at Seite 37 Bedienungsanleitung DF 1200N ...
Page 41: ......