TRANSPORT
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
29
WT39
TRANSPORT
For proper transport, follow the instructions and information on the transport packaging
regarding centre of gravity, attachment points, weight, means of transport to be used and
prescribed transport position, etc.
Transport the product in its packaging to the place of installation. When lifting, carrying and
depositing the load, make sure that you are in the correct posture:
•
Lifting, Depositing
Ensure stability when lifting / setting down (legs hip width).
Lift / lower load with bent knees and straight back (like weightlifter).
Do not lift / lower the load jerkily.
•
Carrying
Carry load with both hands as close to body as possible.
Carry load with straight back.
Always secure the assembled
product
during transport in the transport position to prevent
damage to the
product
.
ASSEMBLY
12.1
Preparatory activities
12.1.1
Checking delivery content
Always note visible transport damage on the delivery note and check the product immediately
after unpacking for transport damage or missing or damaged parts. Report any damage to the
product or missing parts immediately to your retailer or freight forwarder.
12.2
Assembling the product
The product has been disassembled for transport and must be assembled before use. Follow the
instructions below:
Needed tool:
Wrench SW 10, crosshead screwdriver
1.
Table legs – left side
8 x AA
Bolts
8 x CC
Washers
8 x BB
Nuts
•
Align holes in cross bracing (3L) and (4L) to table
legs (1L) and (2L)
•
Insert bolts (AA x 8) through matching holes as
shown – four bolts per cross bracing
•
Fasten with washers (CC x 8) and nuts (BB x 8)
NOTICE:
Do not over tighten!