OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
16
UBM 305
To set the cutting table loosen the screw and adjust the
table to a position so that the blade has a free run. After
the setting retighten the screw
For bending the different segments can be removed or
replaced, depending on workpiece size, so that a defined
bending edge can be generated. For this purpose, loosen
the screw of the corresponding segment to move or
remove this. After new setting retighten the screw.
For rolling function the rear and upper roller can be adjusted. To
adjust the distance and thus the roll diameter use the set screw at
the rear side of the machine. If this role is not adjusted in parallel,
for example, conical shell are produced.
To remove the front upper roll turn the thumb screw by 90° and unscrew the clamp screws.
12.5
Bending
The bending operation is performed between male and female dies and rotating handle bar.
Repeated bends can be made by adjusting hex head bolts to the desired height. Adjust the hex
head bolts so that desired bend is achieved at both ends of die. Loosen cap screw on male die
clamp bar and mount male die combination that gives desired bend length. Make sure the
material stop angle iron is pointed “up” for bending operations. Adjust material to desired position
and secure with cap screws. The female die is set at the factory and should need no adjustment.
If the female die is removed or replaced, mount die and secure it with shoulder bolts. Make sure
that the female die is mounted directly under male dies so that edge of male die fits into groove
of female die.
Summary of Contents for UBM305
Page 42: ......
