HOLZMANN MASCHINEN Austria www.holzmann-maschinen.at
Strana 44
OSCILAČNÍ HRANOVÁ BRUSKA / OSCILLATING EDGE BELT SANDER KOS 3000C
15
MAINTENANCE
A T T E N T I O N
Don’t clean or do maintenance on the machine while it is still connected
to the power supply:
Damages to machine and injuries might occur due to unintended
switching on of the machine!
Therefore: Switch the machine off and disconnect it from the power
supply be-fore any maintenance works or cleaning is carried out
The machine does not require extensive maintenance. If malfunctions and defects occur, let it be
serviced by trained persons only.
Before first operation as well as later on every 100 operation hours you should lubricate all con-
necting parts (if required, remove beforehand with a brush all swarfs and dust).
Check regularly the condition of the security stickers. Replace them if required.
Check regularly the condition of the saw band and the saw band guide.
The good condition and perfect adjustment of the guiding rollers is essential for a smooth band
guidance and a clean cut.
At least all six months or all 500 working hours the lateral cover of the machine take to have a
full admission for cleaning of her parts.
Store the machine in a closed, dry location.
N O T I C E
Clean your machine regularly after every usage – it prolongs the machines lifespan and is a
pre-requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!
15.1
Maintenance plan
After each workshift:
Remove chips and sanding dust from the device
After 10 hours of operation:
Check all screw connections and tighten if necessary.
15.2
Storage
Tension the sanding belt of the belt sander.
Store the machine in a dry and well ventilated place.
Summary of Contents for KOS 3000C
Page 60: ......
