HOLZMANN MASCHINEN HOB 410PRO, User Manual

Page: 38 / 65

MAINTENANCE
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 38
HOB 410PRO
4 Table bearings

Cleaning and lubricating of the table bearings
5 Sliding surfaces of
mortising unit

Cleaning and lubricating of the sliding surface
6 Height adjustment of
mortising unit

Cleaning and lubricating of all levers and spindles
14.2 V-belt
Remove cover. Check the tension. The belt should not yield more than
10mm.
If tensioning of the belt is necessary proceed as follows:
Loosen the motor bracket screws. Adjust the v-belt tension by raising /
lowering the motor. Tighten the screws when the tension is correct and
reinstall the cover.
14.3 Replacement of blades
W A R N I N G
When working on the blades always wear protective gloves!
Injuries to the hands from sharp cutting edges!
1 Spring 2 Blade 3 Gib 4 Locking screw 5 Planer shaft
 Unlock eccentric locks and unfold planer tables
 Loosen the fixing screw (4)
 The springs (1) push out the blade (2) automatically
 Disassemble the blade (2) and the gib (3)
 Clean all parts and planer shaft thoroughly
 Insert the new blade and the gib
 Press blades down and tighten with locking screws
 Blade must not protrude more than 1.1 mm!
 Recommendation: Set distance to 0.7 - 0.8 mm
 Do not use blades with a height of less than 20 mm because low clamping surface
 Tighten the locking screw firmly. Tightening Torque: 24 Nm
 Consider the rotation direction of the planer shaft, when mounting the blades