HOLZMANN MASCHINEN ED1080ADIG, User Manual

Page: 48 / 121

SAFETY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 48
ED1080ADIG
 The machine may only be operated, serviced or repaired by persons who are familiar with
it and who have been informed of the hazards arising from this work.
 Ensure that unauthorised persons maintain a safe distance from the machine and keep
children away from the machine.
 When working on the machine, never wear loose jewellery, loose clothing, ties or long,
open hair.
 Hide long hair under hair protection.
 Wear close-fitting protective clothing and suitable protective equipment (eye protection,
dust mask, ear protection; gloves only when handling tools).
 Metal dust can contain chemical substances that can have a negative effect on health.
Work on the machine should only be carried out in well-ventilated rooms. If necessary,
use a suitable extraction system.
 If there are connections for dust extraction, make sure that they are properly connected
and in working order.
 Always work with care and the necessary caution and never use excessive force.
 Do not overload the machine!
 Shut down the machine and disconnect it from the power supply before carrying out any
adjustment, conversion, cleaning, maintenance or repair work. Before starting any work
on the machine, wait until all tools or machine parts have come to a complete standstill
and secure the machine against unintentional restarting.
 Do not work on the machine if it is tired, not concentrated or under the influence of
medication, alcohol or drugs!
 Do not use the machine in areas where vapours from paints, solvents or flammable liquids
represent a potential danger (danger of fire or explosion!).
15.5 Electrical safety
 Make sure that the machine is earthed.
 Only use suitable extension cords.
 Proper plugs and sockets reduce the risk of electric shock.
 The machine may only be used if the power source is protected by a residual current
circuit breaker.
 Before connecting the machine turn the main switch to position "0".
15.6 Special safety instructions for lathes
 Clamp the workpiece firmly before turning on the lathe.
 Clamp the lathe tool to the correct height and as short as possible.
 Do not wear gloves when turning!
 Keep sufficient distance from all rotating parts.
 Switch off the lathe before measuring the workpiece.
 Remove the clamping key from the chuck after each tool change.
 Never remove any chips by hand! Use a chip hook, rubber wiper, hand brush or brush.
 When using cooling lubricants, observe the manufacturer's instructions and use a skin
protection agent if necessary.
15.7 Hazard warnings
Despite intended use, certain residual risks remain when operating the machine. Due to the
design and construction of the machine, hazardous situations may occur which are identified as
follows in these operating instructions:
D A N G E R
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.