HOLZMANN MASCHINEN DKS 21PRO, User Manual

Page: 21 / 38

HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 21
DKS 21PRO
13 SAFETY
13.1 Intended Use
The machine must only be used for its intended purpose! Any other use is deemed to be a case of
misuse.
To use the machine properly you must also observe and follow all safety regulations, the
assembly instructions, operating and maintenance instructions lay down in this manual.
All people who use and service the machine have to be acquainted with this manual and must be
informed about the machine's potential hazards.
It is also imperative to observe the accident prevention regulations in force in your area.
The same applies for the general rules of occupational health and safety.
The machine is used for:
Cutting edged wood or wood-like workpieces.
Any manipulation of the machine or its parts is a misuse, in this case HOLZMANN-
MASCHINEN and its sales partners cannot be made liable for ANY direct or indirect
damage.
W A R N I N G

Use only blades allowable for this machine!

Never use a damaged blade!
HIGHEST RISK OF INJURY!
Ambient conditions
The machine may be operated:
humidity max. 70%
temperature +5°С to +40°С (+41°F to +104°F)
The machine shall not be operated outdoors or in wet or damp areas.
The machine shall not be operated in areas exposed to increased fire or explosion hazard.
Prohibited use
 The operation of the machine outside the stated technical limits described in this manual is
forbidden.
 The operation of the machine without provided protective devices is prohibited.
 The use of the machine not according with the required dimensions is forbidden.
 The use of the machine not being suitable for the use of the machine and not being
certified is forbidden.
 Any manipulation of the machine and parts is forbidden.
 The use of the machine for any purposes other than described in this user-manual is
forbidden.
 The unattended operation on the machine during the working process is forbidden!
 It is not allowed to leave the immediate work area during the work is being performed.
 Round workpieces may only be cut with suitable holding devices.