HOLZMANN Maschinen GmbH www.holzmann-maschinen.at
Strana 29
D 510F
11.3.4
mounting the tool rest
Remove the tailstock from the machine bed.
The tool holder (
10
) on the machine bed defer.
The tool rest (
11
) Clamp mounting on the bracket (
10
)
and with the clamping levers (
A
).
The tailstock slide it back into the machine base and
clamp.
11.3.5
mounting the toolholder
remove the screws (
C
) from the machine.
screw on the toolholder (
B
) on the machine.
11.3.6
Electrical connection
Only a qualified electrician is authorized for the electrical connection, including the installation of
the supply part. This must be cut off before the electrical connection. Only when the main power
supply is cut off, each contact can be closed. The cowl box is attached to the back of the machine
body. There is also a junction box on the side, which you have to connect only to the marking.
11.3.7
Earthing connection
A T T E N T I O N
When working on an ungrounded machine:
Serious injury due to electric shock in the event of a malfunction possible!
Therefore:
Machine must be grounded and be connected to a grounded outlet
The electrical connection of the machine is ready for operation on a grounded electrical outlet!
The plug must be connected only to a properly fitted and grounded electrical outlet!
The supplied plug must not be changed. If the plug does not fit or is defective, only a qualified
electrical engineer may modify or replace these plugs!
10
B
A
11
C
Summary of Contents for D 510F
Page 45: ......