MAINTENANCE
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
33
BT 46
15
MAINTENANCE
A T T E N T I O N
Don’t clean or do maintenance on the machine while it is still connected
to the power supply:
Damages to machine and injuries might occur due to unintended
switching on of the machine!
Therefore: Switch the machine off and disconnect it from the power
supply be-fore any maintenance works or cleaning is carried out
The machine does not require extensive maintenance. If malfunctions and defects occur, let it be
serviced by trained persons only.
Before first operation as well as later on every 100 operation hours you should lubricate all con-
necting parts (if required, remove beforehand with a brush all swarfs and dust).
Check regularly the condition of the security stickers. Replace them if required.
Check regularly the condition of the saw band and the saw band guide.
The good condition and perfect adjustment of the guiding rollers is essential for a smooth band
guidance and a clean cut.
Store the machine in a closed, dry location.
N O T I C E
Clean your machine regularly after every usage – it prolongs the machines lifespan and is a
pre-requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!
15.1
Maintenance plan
After each workshift:
Remove chips and sanding dust from the device
After 10 hours of operation:
Apply some 30 weight oil on the sleeve bearings (fig.r).
Release belt tension and apply only 2 drops of oil in the oiling
hole. Then adjust the belt tracking
15.2
Belt replacement
Remove the cover after releasing the screw. Loosen three screws to allow drive pulley to shift
enough to place drive belt around them. Change the belt and adjust the tension of the new belt
by placing a screwdriver in the adjusting hole by pushing up on the screwdriver to apply the
tension (fig.s). The right tension is, if you can grab the belt about 1cm (fig.t).
Summary of Contents for BT 46
Page 93: ......
