e-mail: [email protected]
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.
Holtkötter
®
and Holtkötter Leuchten
®
are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
Please make sure the following parts are included:
1. Lamp Base
(A)
with Punkt1 (*P1) dimmer
(D)
2. Bulb
(B)
: 100 Watt Bayonet Base Halogen Bulb by Osram
(Order Code: 9250*100-DC/CL)
3. Glass Shade
(C)
Install the Bulb and Glass Shade
1. Install the new bulb, being careful not to touch the bulb envelope with your bare
hands. Hold the bulb at the porcelain grip, push it down slightly and turn it clockwise.
2. Once the bulb is installed, place the threaded end of the glass over the bulb and onto
the socket.
3. Screw the glass shade down on the fixture until it is firmly in place.
4. Your lamp is now operational.
Note of Caution
The recommended replacement bulb for this fixture is the 100 Watt Osram Bayonet Base Halogen
bulb. Use of other brands of unknown quality may cause a risk of overheating.
Replace the Fuse
An integrated fuse to protect the dimming circuit can be found in the box housing
the plug. Please check the fuse first, in case the lamp does not come on.
A four (4) Amp replacement fuse can be found on the Holtkoetter parts website:
http://www.holtkoetter.com/products/parts/fuse-4amp.aspx
or at your local automotive
or electronics parts store.
1. Unscrew the screws (G) located on
each corner of the plug housing (E).
2. Open the housing to reveal the circuit
board.
3. Locate the black box inside labeled
Fuse 5 x 20
(F)
and open it.
4. Remove and discard old fuse; replace
with the new fuse.
5. Close the small fuse box and the plug
housing.
6. Replace and tighten the four screws
on the outside of the plug housing.
B
C
A
D
F
G
E
Halogen Table Lamp
No. 6391*P1
