20
RIGGING POINTS
The Modul 80-S provides eight M10x1.5 threaded rigging
attachment points made of stainless steel (EN 1.4305 /
AISI 303), four front-facing and four rear-facing. The
M10x1.5 threads are integrated on both ends of four
so-called “Suspension Bolts” that are integrated into the
Loudspeaker Cabinet. These rigging points are intended
for direct attachment to a rigid rigging system, and for
supporting the Audio Module.
There are two additional M10x1.5 threaded safety points
(EN 1.4305 / AISI 303) integrated on the back of the Audio
Module for secondary safety cable attachment (optional).
To safely rig the MD80-S, all eight
M10 points must be used together.
Each rigging screw shall be fixed
with an appropriate torque not
exceeding 65 Nm.
!
IMPORTANT SAFETY AND LEGAL NOTE
:
A rigging system must be designed and used in
accordance with local, state, federal, and industry
regulations. It is the user’s responsibility to
evaluate the reliability of any rigging method
for their application. Rigging should only be
designed and carried out by experienced
professionals. Any rigging design must be verified
and approved by a qualified structural engineer.
HOLOPLOT cannot take any liability and
responsibility for any custom rigging system.
RIGGING THE AUDIO MODULE
HOLOPLOT currently does not offer any general rigging
options for X1 Audio Modules. The following information
is intended to enable a third party to design a custom
rigging system.
3D CAD files of the Audio Modules are
available from HOLOPLOT on request.
FRONT
800
600
30
30
225
225
Installation and Cooling Requirements
All measurements given in mm
BACK
30
165
30
165
BACK
30
30
225
225
600
Summary of Contents for MD80-S
Page 1: ...HOLOPLOT X1 Modul 80 S User Manual Version 1 0 en ...
Page 45: ......
