HOLOPLOT MD80-S, User

Page: 21 / 45

21 X1 MD80-S Manual 1.0 en
Front cover
grille
Back
housing
2.1
3.8
18.0
4.8
22.0
M10x1.5
4.8
19.5
14.7
M10x1.5
Installation and Cooling Requirements
AREAS NOT TO BE COVERED
To ensure best performance of a HOLOPLOT Audio
Module, a rigging system should not cover any of the
loudspeaker drivers and subwoofer ports at the front of
the Audio Module.
Furthermore, when designing a rigging system for an
array of Audio Modules, the four infrared transceivers
on the sides of the Audio Module should not be covered.
Obstructing these sensors will prevent the Audio Module
from automatically recognizing and configuring its
position within an array.
The eight M10 rigging points as well as the two
additional M10 safety points are threaded to a depth of
19 mm. The threads are recessed by ca. 4 mm from the
outer surface. Hence, ensure the M10 fasteners used
are long enough to engage sufficiently with the threads,
but do not exceed 18 mm depth into the Audio Module
from the outer surface.
FRONT
370
75
75
15
60
x2
x4
370
TOP / BOTTOM
47
LEFT / RIGHT
34
15
35
105
105
This is especially relevant for larger
arrays in order to reduce setup time.
Single module deployments do not
require any array configuration.
In case automatic configuration is not
available due to obstructed infrared
transceivers, the Audio Module
position can be configured manually
via
HOLOPLOT Plan .
The areas not to be covered are shown in red in the
following illustrations, along with relevant dimensions.