Hologic R2 DM, User Manual

Page: 90 / 106

Part 6: Maintenance
6.4. Running the Weekly Tests
Three tests must be run weekly to ensure optimal system performance. Always run
the tests together and in this order: Algorithm on top, then Processor, then Scanner –
think ‘APS’!
X
To run the weekly tests
1
Stack the test sheets and films as shown. Note that the test films are ordered as if they
were ordinary films.
Important! If your system does not have the CAD license, do not run the Algorithm
and Processor tests. Run only the Scanner test films.
Test #3- Scanner
9999999901
Sheet #1 Algorithm
Algorithm
Sheet #2 Processor
Processor
Scanner
Film #1 Processor
Film #2 Processor
Sheet #3 Scanner
Film #1 Scanner (Step)
Film #2 Scanner (MTF)
1
2
Test #2-
Pro
cessor
9999999905
Pro
cessor
Test 1
Pro
cessor
Test 2
Test #1- A
lgorith
m
No film
s required
9999999906
P/N 10743 Rev B
2
Place the stack in the input tray and touch
Start
. The computer recognizes the test
film barcode numbers and automatically changes to Test mode. The test requires
about five minutes to complete.
3
When done, review the results by touching the
Controls
tab and then selecting the
Performance
option.
4
Verify that all test results read ‘PASSED’.
•
If all tests pass, you’re done for the week.
•
If any test reads FAILED, rerun ALL the tests. Be sure that the test sheets and films
are loaded in the correct order. If any test fails again, power-cycle the system (see
‘
6.2. Power-Cycling the System ’) and rerun all the tests.
•
If any test fails again, call your Hologic service representative.
82 R2 DM User Manual – PN MAN-01044 Rev 001