HL-140 E12 / HL-160 E12 / HL-190 E12 / HL-220 E12
N-120EL12 / N-140EL12 / N-165EL12 / N-195EL12
Rev. F
8/2/18
Page 36
Linchpin(s) on the platform
E.
Check whether the control box has been connected correctly.
F.
Pull out and rotate the emergency stop button.
The scissor lift activates the tilt protection for 10 seconds (when height is below 4 metres).
Once the warning signal is off, you can operate the scissor lift with the control box.
5.3
Switching off
1.
Retract the platform manually (if necessary).
2.
Lower the platform.
3.
Press the emergency stop button.
4.
Disconnect the control box and store it safely.
5.
Turn the key in the main switch a quarter turn anticlockwise.
6.
Remove the key from the main switch.
5.4
Platform during transport
If the platform guardrails were folded down during transport, it is necessary to make sure they are
fitted correctly, including the linchpins, before the scissor lift is used again.
Note!
Never use the scissor lift if the linchpins are not all fitted.
The guardrail sections may never be removed when using the scissor lift.
The platform must be completely retracted and secured during transport.
