11. Maintenance Procedures
104
To replace an upper headlight, indicator, and position light bulb:
1. Unscrew the light trim.
2. Remove the protective rubber cap from behind the light bulb housing.
3. Detach the plug connector from the light bulb.
4. Rreplace the defective bulb with a new one according to Holder's specifications. See
Light bulbs
section.
5. Attach the plug connector back to the bulb.
6. Reinstall the protective rubber cap.
To replace an indicator, parking, and tail light bulb:
1. Remove the rear light lens from the base of the tail light by carefully lifting the holders from both
sides with a small screwdriver and pull the lense away.
2. Replace the defective bulb with a new one according to Holder's specifications. See
Light bulbs
section.
3. Press the lens back into the holders and ensure that it is secured.
Applying corrosion protector
The tractor requires corrosion protection before winter service of every 500 operating hours (?). Holder
recommends to use permanent protective wax as corrosion protector. This procedure provides
instructions on how to apply corrosion protector.
Before applying corrosion protector:
1. Read and follow the manufacture's instructions for the product to be applied as corrosion
protector.
To apply corrosion protector:
Danger:
Risk of fire, corrosion protector is flammable
l
Do not smoke or light an open fire while handling corrosion protector.
l
Do not allow corrosion protector to contact hot engine components.
Failure to comply can result in serious or fatal injuries, and damage to the tractor.
1. Allow the tractor to cool before applying corrosion protector.
2. Clean the tractor thoroughly (?) and let it dry.
3. Coat the tractor (where?) once or twice using a spray pistol, manual atomizer or brush.
Checking bubble formation in air conditioner
This procedure provides instructions on how to check bubble formation in the air-conditioner (AC).
