HOKUYO AUTOMATIC UAM-05LP, User Manual

Page: 123 / 155


Document No: C-61-00003-3


7.18 Read configuration from UAM
User can check the current settings or confirm the configurations of the UAM by performing the following
steps.
a) Confirm the UAM and UAM Project Designer is connected.
b) Select Load settings on the sub panel window. Progress panel will appear (Figure 7-54) showing the
state. If this button is clicked without connecting the UAM a dialog box will appear to read settings
from the SD card (refer to section 7.9.1).
Figure7-54 Reading the configuration of UAM
c) When reading is complete panel will disappear.
d) Confirm the General, Function and Area settings. Modify the settings if necessary and click transmit to
write the configuration to UAM.
7.19 Open project file
User can open UAM project file by performing the following steps.
a) Click File from the menu bar.
b) Click Open
c) Dialog box will appear (Figure 7-55). Select the project file [*****.hucx] to open.
d) Application reads the contents of project. Confirm the General, Function and Area settings. Modify the
settings if necessary and click transmit button to write the configuration to UAM.