BA_PH_546-100_EN_06-22.docx
43
12
Fine adjustable Table Rollers
(Option)
12.1
Adjusting the Table Rollers
When equipped with this option, two adjustable table rollers are built
into the thicknessing table for better sliding of the wood.
•
The knurled thumbwheel (
G
) is used to adjust the rollers according to
the condition of the wood. The adjustment range is approx. 1 mm. The
planing result deteriorates the higher the table rollers are set.
•
With full stop left, the rollers are in lowest position
→
Use this setting on dry, well-dressed wood.
•
With full stop on the right, the rollers are in the uppermost position
→
Use this setting on damp, resin-rich or non-straightened wood to
ensure safe feeding.
The article number of this option can be found in section
Figure 53: Adjusting the table rollers
13
Changing the Planer Knives
Switch off the machine during maintenance and repair work and secure it against being
switched on again unexpectedly! Lock the main switch with a padlock!
Even when stationary, cuts from the knives are possible!
Always wear protective gloves when changing the knives!
13.1
Changing the TERSA Knives on an All-Steel Cutter Block (standard)
Only use original replacement planing knives from the manufacturer. The blades must always be the same
length as the maximum planer width (630 mm with 546|100).
•
Knock back the pressure bar segments using a hammer in
combination with the brass wedge (
3
) included in the delivery
or a piece of wood. Please do not use a screwdriver or similar
made of steel, otherwise the blades will be damaged!
•
Pull out the knife (
1
) sideways
→
Turn the knife resp. replace and reinsert it.
•
The knives are automatically tensioned to the correct flight
circle by the centrifugal force acting on the pressure bars (
2
).
•
To ensure absolute clamping of the knives after changing the
knives, an initial planing with hardwood over the entire planing
width is necessary.
Suitable replacement knives for your Tersa cutter can be found
in section
Figure 54: Changing Tersa knives
G
2
3
1
