BA_PH_546-100_EN_06-22.docx
32
•
With optional pull-out (automatic outfeed) of the thicknessing table (
36
) and short workpieces switch on
the feed with selector switch (
29
).
•
Start cutter block with push button (
14
).
•
Only start working when the machine has reached full speed (after approx. 10 s).
Switching OFF
•
Switch off the feed by pressing button (
15
).
•
With optional pull-out (automatic outfeed) of the thicknessing table
(
36
) turn the selector switch (
29
) to
the “
OFF
” position
.
•
Stop cutter block with push button (
14
).
•
Turn off main switch (
35
.
9.1.3
Combined Working
The 546|100 can be used in combination. This means that surface planing
& jointing can be done in the front area and thicknessing in the rear (oppo-
site) area.
To do this, the following steps must be observed:
•
Push the planing fence to half the planing width of 315 mm and lock it
in the middle position with the locking pin (
17
).
•
Turn selector switch (
28
) to the right to the inclined position.
Figure 19: Thicknessing controls
•
Turn main switch (
35
) to position
“
I
”
.
•
Adjust the infeed table and the thicknessing table to the desired position as described before.
•
Start cutterblock with push button (
2
) or (
14
).
•
This allows surface planing & jointing on a width of max. 315 mm at the front and thicknessing on a width of
max. 315 mm on the rear side.
Do not surface plane and thickness plane at the same time, but only one after the other!
The cutter block is to be loaded with only one work cycle.
For workpieces that exceed the dimension of 315 mm during thickness planing, the
machine is automatically switched off via a flap stop.
9.1.4
Emergency Stop System
In case of an emergency, the machine can be shut down via the following two switches:
Figure 20: Emergency stops
•
Emergency stop button (
19
) in the thicknessing area
•
Emergency stop button (
8
) in the surface planing & jointing area
0 II
1
2
3
4
5
0
.
.
.
.
.
.
Optional
15
16
28
29
14
19
8
