HOGG & DAVIS ODP 20-4, Manual

Page: 10 / 64

ODP 20-4
2,000 Lb. Four Drum Puller
- - 10 - -
© COPYRIGHT 2016 HOGG & DAVIS, INC
Pulling Control
The following instructions explain how to properly set up the unit
when it is to be used as a puller and have a pulling rope UNDER
TENSION. Use of these instructions assumes that all controls are
at the same setting when the pulled previously stopped.
1. Begin to slightly actuate the joystick to take up
2. Release the brake
3. Actuate the joystick to take up as desired (if reel does
not begin to move, slightly increase the Hydraulic
Pressure Control until it does.
Level wind
This unit is equipped with an automatic diamond lead screw
level wind system. No manual operation of the unit is required.
Make sure shaft if properly pinned and lubricated prior to
operation.
IF MACHINE IS TO BE USED FOR FIBRE OPTIC INSTALLATION, REFER
TO THE CABLE MANUFACTURER FOR PROPER TENSIONING
TECHNIQUES. FAILURE TO CONSULT MANUFACTURER MAY
DAMAGE CABLE AND VOID WARRANTY.