Hofmann Snap-on Y2k, Service Manual, Page: 49 / 99

Seite 49 von 99
Priority ID
Prior. ID Description
0
Critical error (will be recorded in user mode)
1
Warning message
2
For information only
3
All of above, but will not be recorded in the error record (persistent objects p30 to p39)
Error ID
The table lists the error codes and gives some examples for an error.
Error ID Limits Description
F01
Not complete
F02
Invalid job
Mod 2D, Brake :
Module gets invalid event.
Mod 49, Drive system : Internal error, command not valid in actual mode of operation
Mod 66, Meas Control : Internal error. Module gets invalid user event.
command not valid in actual mode of operation
Mod C1, Self-test : Self-test failed, see error record for more information
(kernel register err0,...err9 or User interface: C28).
F03
Out of memory
F04
Out of range
Mod 27, Temperature:
Out of Range
F05
Buffer full
F06
Channel not found
F07
Not found
Mod 41, ASS :
Time client not found
Mod 44, SAPE : Time service not found during unregister
Mod C1, Self-test : Self-test failed, result of test invalid
F08
Already exists
F09
In use
Mod 44, SAPE :
AWP already in use
Mod 49, Drive system : Internal error, command not valid in actual mode of operation
Many "490F09" errors in the error record indicates a
malfunction of the pedal.
F0A
End of file
F0B
Drive full
F0C
Bad name
F0D
Xmit error
Mod C3, User Interface :
Communication Error between balancing kernel and user
interface (BK <- UI). Machine should be restarted.
This error can caused by a bad connection of the RS232-E
serial line. Check external and internal cabling.
F0E
Format failed
F0F
Bad parameter
Mod 41, ASS :
Invalid time specified
Mod 44, SAPE : Bad parameter during calling time service
Mod 81, cmd : Parameter of a kernel command is bad.
Such an error can occur as a result from a hardware
malfunction.