10
10.0
CONTROL DESCRIPTION AND FUNCTIONING TEST
6
11
16
12
The functioning test has to be issued without tire. Take care that during the test, other machine
elements do not hold up operations.
1.
Horizontal swing arm foot control
2.
Wheel lifter foot control
3.
Inflating foot control
4.
Self-centring spindle 2-speeds rotation foot control
5.
Lever-less tool control valve
6.
Bead breaker blade
7.
Bead breaking arm
8.
Dual-speeds bead breaking arm opening botton
9.
One-speeds bead breaking arm opening button
10.
Self-centring table
11.
Self-centring clamp
12.
Lever-less mounting/demounting tool
13.
Release/fastening tool support arm
14.
Rubber pad
15.
Inflating manometer
16.
Quick rim fit clamping device
5
10
7
1 2 3 4
15
13
14
8
9
11
Take care of starting the tire bead breaking operations
away from the pressure valve/sensor, in order to avoid
damages.
CAUTION!
Be sure the bead blade do not hit the rim during breaking
operations: the rim could be damaged irremediably.
Avoid to grease the tire sensor.
CAUTION:
During bead breaking operations, pay attention to press the
tire bead only. Do not press the tire shoulder.
12.0 BEAD BREAKING
11.0 USE
It is necessary to deflate the tire and remove the calibration weights before starting demounting
operations.
The tire changer use is divided in three parts:
A)
Bead breaking operations
| B)
Demounting
| C)
Mounting
•
Remove all the rim calibration weights with the dedicated tool. Take care
and avoid rim damages.
•
Check the tire is deflated.
•
Use the bead breaker plastic protection in case of alloy rims.
• Pressing buttons (
8
) and (
9
) (see picture 1, pag. 10), position the bead
breaking tool so that the tire leans against the plug (
14
).
• Lean the tire against the rubber plug (
14
) and begin bead breaking ope
-
ration starting from outer bead [fig. 1].
• Pressing button (
9
), bead break the tire.
• Press the button (
8
), in order to release the bead breaker tool, roll the
tyre ¼ and press again the button (
9
) to go on with bead breaking opera
-
tions.
•
Repeat the procedure till the tire bead breaking is completed.
•
The manufacturer suggests greasing the tire while bead breaking. This
will help even during demounting operations.
• Repeat the above procedure for inner bead.
Fig. 1
caution
caution
13
Summary of Contents for Megamount Twister EVO CP
