8
7.0 TRANSPORT
The machine has to be moved while it is packed and through tran
-
spallet or forklift truck of suitable capacity, using the dedicated forks
slots (see picture).
8.0 UNPACKING
Once the packing has been removed, check carefully the machine is not damaged.
In case you are not sure the machine is damaged or not, do not use the machine and ask the intervention of trained
personnel (ask your dealer).
Packing elements should be kept out of children reach. The packing elements should be carried off to dedicated areas
in case they were polluting or not biodegradable.
Be sure that the lifter could stand the tyre changer weight (min. 600 kg).
C
B
A
In case the machine has already been unpacked, follow the instruction
below:
- Protect angles properly;
- Do not use metallic cables for machine lifting.
Packing dimensions (mm.)
Gross weight
A
B
C
Kg
1100
1100
2040
495
9
9.2 Positioning and connections
Position the tire changer on a levelled, smooth and no-slippery fitting floor. Be sure the floor can stand machine weight.
It is not necessary to screw up machine to the floor. In case the machine is installed outside, be sure it is protected
against atmospheric events properly.
The tyre changer has to be connected to a suitable electric system equipped with a suitable grounding.
NOTE:
in case the machine is delivered without plug , the user will assemble one according to machine voltage and in
force rules.
At installation, check the supply voltage corresponds to machine one, according to label data.
Machine has to be disconnected from both pneumatic and power supply while first positioning
and further handling.
9.0 INSTALLATION
9.1 Machine positioning spaces
It is necessary to take into consideration the in force Workplace Safety
Rules, while choosing the machine positioning.
The tyre changer has to be connected to the power and pneumatic supply.
Be sure that the floor can stand the machine weight and max. burden.
In order to ensure the correct machine functioning, be sure that it is placed
to right distance from other devices, as per picture fig. 1.
The manufacturer cannot be considered responsible for any damage caused by a wrong
electric connection.
Every intervention on the electric system should be executed by trained personnel.
The pneumatic supply system should join a min pressure of 8 bar and a
max . pressure of 10 bar.
Connect machine to the pneumatic plant through the connection on reg-
ulating filter group.
800
mm
Fig. 1
200
mm
300
mm
11
Summary of Contents for Megamount Twister EVO CP
