Operating and Maintenance Manual
18
©
HOFFMANN PP2-NCF
• Version 7.267 • 12-2017
10
General Safety Rules in accordance with DIN 1870-9
DANGER: The following safety rules must
be followed at all times!
Read and understand this operator manual thoroughly and store it
in a safe place for future reference.
Heed all safety warnings and all applicable rules and regulations,
including but not limited to all applicable OSHA rules, when
operating or performing maintenance or set-up procedures on this
equipment.
1. HOFFMANN Service Technicians will instruct machine operators in the
proper use of this equipment upon installation and set-up.
2. The HOFFMANN PP2-NCF dovetail routing machine may only be
operated by trained personnel who have read and understood the
operator manual. The manual shall be kept in a safe location, easily
accessible for future reference.
3. Only trained and authorized persons may be allowed to operate the
HOFFMANN PP2-NCF dovetail routing machine. Untrained or
unauthorized persons are to be kept away from the machine area. The
operator(s) must disconnect the electrical and pneumatic power
supplies when the machine is not under their control.
4. All applicable Safety Rules, including all applicable OSHA rules, are to
be adhered to.
5. Only trained and qualified persons may perform work on the electrical
components of the machine.
6. Before connecting the HOFFMANN PP2-NCF dovetail routing machine
to the electrical power supply, all electrical specifications must be
confirmed with the machine’s data sheet.
7. Never disable, remove or bypass any safety features, guards or
devices!
8. HOFFMANN PP2-NCF dovetail routing machine may only be energized
if no danger for persons or materials is present.
9. All safety features, guards and safety devices must be checked for
proper function at least every three months (always follow
recommended maintenance schedule).
10. Upon discovery of any damage to any part or component of
HOFFMANN PP2-NCF dovetail routing machine, the machine must be
shut off and locked to prevent further operation until all damager and/or
faults are repaired.
11. The operator must inform his or her supervisor immediately upon notice
of any damage or fault on the machine.
