HOESCH Whirlsystem Reviva II, Installation And Operation Instructions Manual

Page: 22 / 84

22
GB
17 Checklist
On the basis of this checklist you can quickly and eff ortlessly deal with defects occurring in your whirl tub. Works connected with the
electric installation can only be performed by authorized experts in this fi eld. Before commencing electric works you should switch off
the whirltub from the power supply!
Defects Reason Remedy
The blower is not working
The pump is not working Lack of the power voltage
230 V, 50 Hz Switch on the initial protection and/or the
current trip device (FI)
Burnt fuse Exchange of fuse by an expert
Dry-run protection is switched on Please fi ll the bathtub above the jets level
Released motor protection against
overheating
Let the motor cool down
Control unit electronics Restart the motor, i.e. stop the current
infl ow for approx. 1 minute
The massage stream
is getting weaker
Drain valve Cleaning the drain valve see point 16.01
Massage jets Clean the jets
What you should do when …
during whirl bathing foam appears?
— Immediately switch the Whirl system and Air-Injection
off ! Drain and rinse the bathtub thoroughly. Remember
to use only appropriate additives for bathing
(the ones
that do not foam and do not contain oils)!
you do not use the whirltub or you are absent (e.g. you are
leaving for a holiday)?
— In fact you do not have to make any special steps.
Like in case of all electric devices it is recommended to
switch the device off with the master switch.
Getting ready to call the HOESCH customer service centre
If removing defects by yourself has not been successful, then
before calling prepare the following information, so that the
customer service centre can fi nd a solution as quickly as possible:
■ Product name/model signs
■ Article number
■ Factory number/serial number of the product (you will
fi nd it on the guarantee card, or on the control unit or on
the product itself)
Example:
HOESCH
Fabr.-Nr.
0H7 00008
■ Purchase date
■ Symptoms of the problem