Hochiki YBN-UA Installation Instructions Download Page 1

 

 

 

 

Hochiki Australia Pty Ltd No.2-1-001/ISS1/FEB17 

 

HOCHIKI YBN-UA(WHT) RECESS BASE ADAPTOR 

The YBN-UA(WHT) is a Recess Base adaptor which allows YBN-R/3(WHT) base and ALK-ASN analogue 
sensor to be flush mounted, this is particularly suited to where unobtrusive detection is required. 

 

Installation 

To install the YBN-UA, a YYA-A fixing kit should be obtained this consists of the parts shown below. 

 

Pressure clamp x 2 

Screw fitting x 2 

 

Screw x 2 

 
Firstly a hole with a diameter of 115mm should be cut in the ceiling tile. The pressure clamps should then be 
fitted to the YBN-UA in a vertical position using the screw fittings and the fixing screws, refer to fig.1. The next 
step is to pull the cables through and fit the YBN-UA into the hole in the ceiling and whilst looking through the 
Recess Adaptor cable hole, loosen the screws until the pressure clamps lower into place refer to fig.2.  Re-
tighten the bracket screws until the pressure clamps are fixed in the horizontal position. 
 

 

 

 

Fig 1 

Fig 2 

 
Once the YBN-UA has been secured, the relevant mounting base needs to be fixed with the M4 x 16mm screws 
supplied. When fitting the base the locating “LED” mark on the base must be lined up with the locating “LED" 
mark on the YBN-UA, please refer to fig.3. Once the base has been fitted the relevant detector/sensor can then 
be attached, please refer to fig.4. 

 
 

 

 

Fig 3 

Fig 4 

Please find below a list of detectors/sensors and the height they will be from the ceiling when fitted to the 
relevant bases. 
 

Height from the ceiling 

Base 

Sensor 

YBN-R/3(WHT) 

ALK-ASN 

26mm 

 

 

 

LED 

Reviews: