© 2009 Onset Computer Corporation
Part #: MAN-CABLE-U23-002, Doc #: 12990-A
HOBO
®
U23-002 Replacement Cable/Sensor (Part # CABLE-U23-002)
The U23-002 Replacement Cable/Sensor replaces a damaged cable on the U23-002. The
replacement cable includes a built-in temperature sensor and an RH sensor.
Contents
•
Cable/Sensor
•
Dome Nut/Grommet assembly (installed on cable)
•
Cable Tie
•
Grease Packet
Required Equipment
•
Adjustable Wrench
•
Utility Knife
Removing the Existing Cable/Sensor
1.
Unscrew the grommet from the case and slide the grommet/dome nut assembly down the cable.
Use a wrench if necessary.
2.
Remove the end cap from the case.
Twist the end cap counterclockwise until the bumps on the cap line up with the notch on the case,
and then pull the cap off of the case.
3.
Slide the board out of the case.
