1
3
4
1
3
2
2
Ref : OM_T2
Issued by : SD
Date : 12/2013
Up-date : 0
Page : 24/44
Copyright HCE 2013 - www.hobie-cat.net
E U R O P E
24
Hobie Cat® Europe
Assembly Manual - Hobie T2
Illustration
Steps
Description
If you do not have the jib furler, go directly to the next page
7
In the rig bag, take the 8 mm shackle and insert
the wires in the same order as indicated on the
drawing :
1 : Trapeze wires for the skipper (on the pin)
2 : Trapeze wires for the crew
3 : shroud wires
4 : p swivel
Attach the shackle with the wires on the mast
tang.
8
Insert the jib halyard rope in the small block at
the end of the black jib halyard, make a buckle
and stop with a figur 8 knot. Attach the two loose
ends at the bottom of the mast.
9
Take the jib furler in the wire bag and connect it
to the two bridle wires using the clevis pins and
split rings.
NB : Caution ! Ensure that the exit hole in the
furler is pointing at the furler cleat on the front
crossbar. Check that the screw on the underside
of the furler is tight. This prevents the outer cover
from rotating.
10
Wind the furler up in a clockwise direction. Leave
enough furler line to reach the furler cleat on the
front crossbar.
Mast set-up : wire assembly (model with jib furler)
