TROUBLE SHOOTING:
Problem
Cause
Solution
Motor does
not turn
1. Battery is not fully charged.
2. Transmitter battery low.
3. Motors not connected.
4. The motor is damaged.
5. Receiver is not bound to Tx.
6. ESC in setup mode.
1. Charge the batteries.
2. Install a full charged battery.
3. Check for connection
between the ESC and
motor.
4. Replace motor.
5. Consult Radio manual and
go through bind procedure
again.
6. Hold model and move
throttle to full postion then
back down to idle.
Model moves
backwards
1. Props installed on the
wrong motors.
1. Swap the props around.
Control surfaces
not moving with
stick input
1. The servo lead is connected
to Rx incorrectly.
2. The servo is damaged.
1. Make sure the servo leads
are connect properly.
2. Replace servo.
Model does not
fly straight
1. Control surfaces not centered.
2. C G is not in the correct position.
1. Adjust the trims on the
transmitter.
2. Reposition lipo as
suggested.
Model does not
climb well
1. The battery is not fully charged.
2. Elevator servo is reversed.
3. CG too far backwards.
1. Charge the battery.
2. Change servo direction
via Tx.
3. Move battery forwards.
Limited Radio
Ranae
1. Transmitter/Receiver batteries
are flat.
1. charge/replace batteries.
