Align Trex SE Setup Guide. version 1.0
Although I have successfully flown nitro and electric helis in the past I only recently discovered that my
setups were never actually correct. The difference in performance of a correctly configured heli and what I
thought was correct is really amazing. This is not a complete build but information on how to correctly
setup your servos, linkage, pitch and throttle curve so you have a smooth operating heli.
The following steps are based on a Trex SE that has been correctly assembled and all components
installed. The radio used is the Spektrum DX6. These steps are specific to the Spektrum DX6 so please
see your manufacturers instructions for placing your radio into the correct helicopter mode, in this case
CCPM, and other options such as servo reversing, gyro gain, etc.
Radio settings, rates, degrees and any
measurements shown in this guide are from my working SE. Do not assume that by using the same
values you will get the same results. Please verify all your settings and general operation of your heli. I will
always try to keep this information updated and error free however it is your responsibility to make sure
your heli is operating correctly.
#1 Radio Setup (Spektrum DX6)
The battery to your helicopter does not need to be connected at this time.
•
First we will set the radio into Heli Mode.
o
While pressing up on the scroll and increase buttons, turn the power switch on. You are
now in System Mode.
o
Press scroll until TYP is displayed.
o
Press increase and select HE.
o
Press scroll until GER is displayed.
o
Press increase and select A
o
To save either turn the radio off or press scroll and increase at the same time.
•
Now we will set options in Function Mode.
o
Turn the radio on if it is not already on.
o
Press scroll and increase. You are now in function mode.