™
™
❏
1. Remove the servo arm screw from the elevator servo.
Loosen the screw in the pushrod screw lock connector.
❏
2. Remove the elevator servo arm by pulling straight up on
the servo arm.
❏
3. Remove the plastic keeper from the pushrod screw lock
connector pin by inserting a hobby knife blade between the
plastic keeper and the servo arm and gently prying it loose.
❏
4. Remove the pushrod screw
lock connector and insert it into the
hole nearest the center of the servo
arm.
❏
5. Re-install the plastic keeper by pressing it on the pushrod
screw lock connector pin. If the plastic keeper is loose and will not
stay on, a new pushrod screw lock connector can be obtained by
contacting
Hobbico Product Support.
The contact information
is shown on page 4 of the Sensei instruction manual.
❏
6. To re-install the elevator servo horn, turn to page 8 of
the Sensei instruction manual and perform steps 1 through 6
of
Check the Radio System
.
With the elevator trim centered,
re-install the elevator servo horn so that it is perpendicular to the
centerline of the elevator servo. Secure the elevator servo horn
to the servo with the servo horn screw.
❏
7. Unplug the LiPo motor battery and switch the transmitter off.
Insert the elevator pushrod in the pushrod screw lock connector.
❏
8. Return to page 5 of the Sensei instruction manual and
continue with
ASSEMBLE THE SENSEI.
IMPORTANT INFORMATION
When we created the Rx-R version of Sensei we expected it to fl own by a pilot with at least some fl ying experience. For this reason
we have increased some of the control throws to make the Sensei more lively and aerobatic. If you are new to R/C and this is your
fi rst trainer, we recommend that you reduce the amount of movement of the elevator to make the model a little more docile.
On page 5, after you have installed your receiver:
