HNC Electric SV-E3 Series, Instruction Manual

Page: 161 / 178

161
The drive and motor do not match. If the drive and motor do not match, clear the EEPROM parameter and
change the motor models.
Appendix
Appendix 1 Recommended wire/cable
Cable name AWG UL Heat-resistance Remark
Motor power cable (750W or less) 18 2517 105
℃
Motor power cable (1KW or less) 14 Note 1) 2501 105
℃
200VAC input (750W or less)
FG cable Note 2)
18 1015 105
℃
200VAC input (1KW or more)
FG cable Note 2)
14 Note 1) 1015 105
℃
Encoder Power
：
22
Signal
：
24
20276 80
℃
Max.20m for shielded cable of 5P(10
cores) (when using shielded
twisted-pair cable)
User I/O 26 1007
80
℃
Shielded twisted-pair cable
Recommended length: 50m or less
Regenerative resistor connection 18 1015 105
℃
Brake 18 2517 105
℃
1P(2 cores)
Main circuit DC power (750W or
less) Note 2)
18 1015 105
℃
Main circuit DC power (1KW or
more) Note 2)
14 Note 1) 1015 105
℃
Communication between the drives
Note 2)
28 20539
80
℃
Ribbon cable 10 cores
Accessories ((2.54mm spacing)
The length of cable depends on the actual situation.
Note 1) AWG16 cable can be used for 1kW motor.
Note 2)For multi-axial drives
Appendix 2 SV- E3 positioner function
1. Overview
This product has the positioning function of using point table.
Preset the data by the point table in the drive and set the Point No. to be started through I/O input by the upper controller. After
inputting the start signal, the positioning will be done according to the selected Point No.
2. Basic setting [2.1 User I/O connector (CN1) wiring]
Table 2.1 User I/O connector CN1 connector pins arrangements
Name Symbol Pin No. Signal name Contents
User I/O CN1 1 24V Drive control power supply 24V input