This surface is
6" to 10" above
the drive- thru
lane surface
INSTALLATION INSTRUCTIONS
Figure 1.
SPP2 Speaker Post
on concrete foundation
Figure 2. Typical site for concrete foundation
Concrete Foundation
For SPP2 Speaker Post
The SPP2 Speaker Post requires a concrete foundation with four
anchor bolts and one or more conduits embedded in it. One
conduit must be installed for the audio cable. Additional
conduit(s) may be required for a vehicle detection cable and/or
for an AC electrical cable. These instructions are for installation
of the SPP2 concrete foundation at new drive-thru sites.
CAUTION: All electrical connections must be made
by a licensed electrical contractor.
If you have any questions regarding this installation, call HME
Customer Support at 1-800-848-4468.
1.0
Equipment Provided
1 ea Template
4 ea Anchor bolt with 2 hexagonal nuts
2.0
Material Required
Concrete, 6 cubic feet
3.0
Procedure
Step 1
Position the foundation so that water
will drain away from the base of the
speaker post. The top surface of the
foundation must be six to ten inches
above the surface of the drive-thru
lane. The side of the foundation must
be 2 feet or less from the side of the
drive-thru lane, and parallel to the lane
as shown in Figure 2.
Build a 24 x 24 inch form with its top
six to ten inches above the surface of
the drive-thru lane. Dig a hole in the
ground to a depth 18 inches below the
top of the form for pouring the concrete
foundation shown in Figure 1.
HM ELECTRONICS, INC.
14110 Stowe Drive, Poway, CA 92064 USA
!
Phone: 1-800-848-4468 Fax: (858) 552-0172
HME# 400262
Rev C 10/29/02
