ServerCall
®
Paging w/Rugged Staff Pagers
Quick Setup Guide
Components
•
JTECH Transmitter
Applies to models: ServerCall (12/24)
& ServerCall Cancel Panel (12/24)
•
Rugged Pagers
•
Rugged Charger
Mount the transmitter to the cook line using the
included brackets. Bracket can also be used as a
stand by reversing its position on the back of the
transmitter.
Step 1
Lock the antenna to the transmitter by placing the
antenna on the connector and twisting left to lock
into place.
Step 2
Plug the power supply in to the transmitter and
then into a standard outlet. A surge protector is
recommended.
Step 3
Compile charger bases and connector wires if
applicable. Plug charger power supply into
charger and then into a standard outlet. Surge
protection is recommended for charging bases.
Step 4
> ‘LO’
on the number display: Battery is below
20% charged and SHOULD NOT be used.
> Flashing BLUE
: Pager is charging and CAN BE
used.
> Solid BLUE
: Pager is fully charged.
>
Allow 4 hours for a complete charge of the
pagers.
Connector Wire
©2017 JTECH, an HME Company logo and product names are registered trademarks of HM Electronics, Inc. All rights reserved.
Step 5
Add pagers to charger slots. You will see a BLUE
light on each pager. This indicates the charging
status.
QSSCRG
-
1