HME Clear-Com ARCADIA Series, User Manual, Page: 100 / 171

User Guide | Arcadia® Central Station
6.2.4 Setting Cable Length Offset (E1)
Cable length offset is used to prevent the DECT or radio signals between transceivers getting
out of synchronization. If transceivers are not synchronized, beltpack handover will not happen
effectively. This is particularly important if you have overlapping transceiver coverage zones
(RF cells) or the beltpacks need to move between coverage zones.
Cable length offset or transceiver sync compensation needs to be set when:
l
The difference in total cable length between transceivers is ≥ 1640ft / 500m (this includes
both fiber and copper cable runs).
Example
TCVR #1: total cable length = 328ft /100m
TCVR #2: total cable length = 2788ft / 850m
The difference in cable length between transceivers = 2460ft / 750m. Therefore, in this case you
must set transceiver cable length on both transceivers. This allows any latency to be calculated
and offset by the system.
In the configuration tool, navigate to: Resources > Transceivers > Details > General > Cable
Length
6.3 Adding IP Transceivers (FS Edge, FS II 1.9)
Note: To add E1 transceivers, see Connecting Transceivers Over E1 on page 96 .
To add IP transceivers:
1. Navigate to Hardware > Resources and select Add Resource . The following screen
appears.
Page 100